Omega Engineering FP-6000 Bedienungsanleitung PDF herunterladen (Seite 5)

Important Safety Information!

CAUTION:

(Standard version) Never remove the flow sensor

from a pressurized pipe. Always wear safety face

protection during sensor installation/removal.

(Hot-Tap version) Follow the recommended

installation/removal instructions in this manual.

Always wear safety face protection during sensor

installation/removal.

Maximum Operating Pressure:

225 psi (15 bar)

Maximum Operating Temperature:

212 °F (100 °C)

Serious bodily injury and/or damage to the sensor

can result if the conditions and specifications

presented in this manual are exceeded. DO NOT

exceed specifications under any circumstances.

Pipe fittings MUST be installed by a certified

welder only. OMEGA will not assume liability of

any kind for improper fitting installations.

The FP-6000 Hot-Tap system's overall specifica-

tions and limitations depend on the lowest maxi-

mum rating of the components associated with the

system. In other words, the Hot-Tap system is only

as strong as its weakest link. For example, a ball

valve, a component of the system, is rated at a

maximum 100 psi @ 185 °F, limiting the entire

system's maximum pressure/temperature rating to

100 psi @ 185 °F. All higher maximum specifica-

tions MUST yield to the component with the lowest

maximum specification.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Keine Kommentare

Omega Engineering FP-6000 Bedienungsanleitung Seite 5